![]() ![]() ZH ELECTRONIC CONTROL MODULES – SERVICE INFORMATION 8E – 77 Replace all ignition keys and program them to the new Sentry Key Remote Entry Module. Using the DRB III, follow the on screen instructions to program the new Sentry Key Remote Entry Module.ģ. Using the DRB III scan tool, follow the on screen instructions to program the new PCM.Ģ. When a Powertrain Control Module (PCM) and the Sentry Key Remote Entry Module (SKREEM) are replaced at theġ. These failuresĪre difficult to detect when a double fault has occurred and only one DTC has been set. pull-ups, drivers, and switched circuits). relays and solenoids) and shorted circuits (i.e. Most PCM failures are caused by internal component failures Note: Before replacing the PCM, be sure to check the related component/circuit integrity for failures notĭetected due to a double fault in the circuit. ![]() STANDARD PROCEDURE – PCM/SKREEM PROGRAMMING PCM/SKREEM programming with DRB III scan tool In this article I share: PCM /skreem programming, programming the sentry key remote entry module, transmitter programming, sentry key verification test etc. There is a specific DRB manual for Chrysler Crossfire. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |